Converter IDC20A to MIPI-10/20T

Converter to connect a IDC20A Debug Cable to a MIPI-10 or MIPI-20T connector on the target.

Pins	Samtec Order No
10Pin MIPI-10	FTSH-105-01-L-DV-K
20Pin MIPI-20	FTSH-110-01-L-DV-K
SAMTEC Connector Dimensions Link to SAMTEC

Placement:
We recommend to place the odd numbers of the target connector on the edge of the board (probe flex cable won't get twisted).

Signal	Pin			Pin	Signal
VREF-DEBUG	1			2	TMS|TMSC|SWDIO
GND	3			4	TCK|TCKC|SWCLK
GND	5			6	TDO|-|SWO
GND (KEY)	7			8	TDI
GND	9			10	RESET-

Signal	Pin			Pin	Signal
VREF-DEBUG	1			2	TMS|TMSC|SWDIO
GND	3			4	TCK|TCKC|SWCLK
GND	5			6	TDO|-|SWO
GND (KEY)	7			8	TDI
GND	9			10	RESET-
GND	11			12	TRACECLK
GND	13			14	TRACEDATA[0]
GND	15			16	TRACEDATA[1]
GND	17			18	TRACEDATA[2]
GND	19			20	TRACEDATA[3]

Note:
This converter does not connect the trace pins of a CoreSight MIPI20T connector since they are not used by IDC20A debug cables.
Whereas tracing via SWO/SWV is supported.