Converter AUTO26 to IDC20A / IDC20A-ETK / TI-14 |
 
|
|
 |
 |
|
|
|
|
|
 Technical Support |
 |
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Order No. | Probe | |
|---|---|---|
| LA-2748 | Converter AUTO26 to IDC20A/IDC20A-ETK/TI-14 |
| IDC20A | IDC20A-ETK | TI-14 |
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Signal | Pin | Pin | Signal | ||
|---|---|---|---|---|---|
 | |||||
| VREF-DEBUG | 1 |  |  | 2 | VSUPPLY (not used) |
| TRST- | 3 | | | 4 | GND |
| TDI | 5 | | | 6 | GND |
| TMS|TMSC|SWDIO | 7 | | | 8 | GND |
| TCK|TCKC|SWCLK | 9 | | | 10 | GND |
| RTCK | 11 | | | 12 | GND |
| TDO|-|SWO | 13 | | | 14 | GND |
| RESET- | 15 | | | 16 | GND |
| DBGRQ | 17 | | | 18 | GND |
| DBGACK | 19 | | | 20 | GND |
 | |||||
| Target connector, top-view | |||||
The signals RTCK, DBGRQ, DBGACK are not supported by the AUTO26 Debug Cable. Do not connect them on the target board.
Recommended Target Connector
- This is a standard 20 pin double row (two rows of 10 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 30.6mm/1.2".
- Examples with housing: Samtec HTST-110-01-L-D (through-hole); Samtec HTST-110-01-L-DV (surface mount).
- Examples without housing: Samtec TSW-110-23-L-D; Berg 67996-120H.
|
Copyright © 2024 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany
Impressum
Privacy Policy
The information presented is intended to give overview information only. Changes and technical enhancements or modifications can be made without notice. Report Errors Last generated/modified: 09-Aug-2024 |
