Converter AUTO26 to JTAG16 for TriCore |
 
|
|
 |
 |
|
|
|
|
|
 Technical Support |
 |
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Order No. | Probe | |
|---|---|---|
| LA-3849 | Conv. AUTO26 to JTAG16-TriCore |
Target Connector Type
Connector Type
- This is a standard 16 pin double row (two rows of seven pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".
Pinout
| Signal | Pin | Pin | Signal | ||
|---|---|---|---|---|---|
 | |||||
| TMS/DAP1 | 1 |  |  | 2 | VTREF |
| TDO/DAP2/USER0 | 3 | | | 4 | GND |
| CPUCLOCK | 5 | | | 6 | GND |
| TDI/DAPEN | 7 | | | 8 | RESET- |
| TRST-/DAPDIR | 9 | | | 10 | BRKOUT- |
| TCK/DAP0 | 11 | | | 12 | GND |
| BRKIN- | 13 | | | 14 | OCDSE-/BREQ- |
| RESERVED/BGRNT- | 15 | | | 16 | GND |
 | |||||
There is a configuration option (jumper) whether the OCDSE- pin is used with the signal OCDSE- or as BREQ- signal for arbitration with the ETAS ETK-S calibration tool.
Compatible Debug Cables
The following debug cables are compatible with this adapter:
|
Copyright © 2025 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany
Impressum
Privacy Policy
The information presented is intended to give overview information only. Changes and technical enhancements or modifications can be made without notice. Report Errors Last generated/modified: 27-Mar-2025 |
