Converter IDC20A to 78K0R/16 for 78K0R Debugger
 Product
| Order No. | Probe |
|---|
| LA-3865 | Converter IDC20A to 78K0R/16 | |
Connector 16 pin
|
Signal
| Pin
| | Pin
| Signal
|
|---|
| | |  | | |
| VSS | 1 |  |  | 2 | RESET- |
| TOOL0 | 3 | | | 4 | VDD |
| N/C | 5 | | | 6 | N/C |
| N/C | 7 | | | 8 | N/C |
| N/C | 9 | | | 10 | N/C |
| N/C | 11 | | | 12 | N/C |
| N/C | 13 | | | 14 | FLMD0 |
| TRESET- | 15 | | | 16 | TOOL1 |
| | |  | | |
The debugger is connected via 16 pin double row connector to the target.
The connection between target and debugger could be a 2-wire connection (TOOL0 + TOOL1).
Between TOOL0 and VDD a Pull-up-resistor of 1,5 kOhm is recommended.
Target Connector Type
- This is a standard 16 pin double row (two rows of 8 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 25.5mm/1".
|
|
- 100 mil to 50 mil Adapters
- Small Footprint for Target Connector
|
 | |
|
Converter IDC20A to 78K0R/16 for 78K0R Debugger
