Converter IDC20A to RL78/14 for RL78 Debugger
 Product
| Order No. | Probe |
|---|
| LA-3866 | Converter IDC20A to RL78/14 | |
Connector 14 pin
|
Signal
| Pin
| | Pin
| Signal
|
|---|
| | |  | | |
| N/C | 1 |  |  | 2 | GND |
| N/C | 3 | | | 4 | N/C |
| TOOL0 | 5 | | | 6 | TRESET- |
| N/C | 7 | | | 8 | VDD |
| EVDD | 9 | | | 10 | RESET- |
| N/C | 11 | | | 12 | GND |
| RESET- | 13 | | | 14 | GND |
| | |  | | |
The debugger is connected via 14 pin double row connector to the target.
RL78 supports only a 1-wire connection (TOOL0) between chip and debugger.
Between TOOL0 and VDD a Pull-up-resistor of 1,5 kOhm is recommended.
Target Connector Type
- This is a standard 14 pin double row (two rows of 7 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".
|
|
- 100 mil to 50 mil Adapters
- Small Footprint for Target Connector
|
 | |
|
Converter IDC20A to RL78/14 for RL78 Debugger
