Target Adaptation AUTO26 to Mictor38 (NEXUS) for MPC5XXX/SPC5XXX
 Product
| Order No. | Probe |
|---|
| LA-3874 | Conv. AUTO26 to MICTOR38 MPC5xxx | |
Connector on Target
Pinout
|
Signal
| Pin
| | Pin
| Signal
|
|---|
| | |  | | |
| (MDO12) | 1 |  |  | 2 | (MDO13) |
| (MDO14) | 3 | | | 4 | (MDO15) |
| (MDO09) | 5 | | | 6 | (CLKOUT) |
| N/C | 7 | | | 8 | (MDO08) |
| RESET- | 9 | | | 10 | EVTI- |
| TDO | 11 | | | 12 | VTREF |
| MDO10 | 13 | | | 14 | (RDY-) |
| TCK | 15 | | | 16 | (MDO07) |
| TMS | 17 | | | 18 | (MDO06) |
| TDI | 19 | | | 20 | (MDO05) |
| JCOMP | 21 | | | 22 | (MDO04) |
| (MDO11) | 23 | | | 24 | (MDO03) |
| RESETOUT- | 25 | | | 26 | (MDO02) |
| WDTDIS | 27 | | | 28 | (MDO01) |
| BGRNT | 29 | | | 30 | (MDO00) |
| N/C | 31 | | | 32 | EVTO- |
| N/C | 33 | | | 34 | (MCKO) |
| BREQ | 35 | | | 36 | (MSEO1-) |
| N/C | 37 | | | 38 | (MSEO0-) |
| | |  | | |
| Connect Pin 39,40,41,42 and 43 to GND |
General Signal recommendation and information
- Signals in brackets show the assigned signal for each pin, but are N/C on the converter.
- If processor does not have a JCOMP pin, leave N/C at the connector.
- If processor does not have a RESETOUT- pin (reset output signal of processor), leave N/C at the connector.
- BREQ and BGRNT are used for communication between debugger and calibration tool. Leave N/C on target.
- EVTI- and EVTO- are optional. Do not connect if used for GPIO or other functions.
Compatible Debug Cables
The following debug cables are compatible with this adapter:
|
