 Target Adaptation for JTAG Debugger for MPC82xx/MPC83xx (ICD)
 Connector 16 pin
|
Signal
| Pin
| | Pin
| Signal
|
|---|
| | |  | | |
| TDO | 1 |  |  | 2 | N/C |
| TDI | 3 | | | 4 | TRST- |
| (RUNSTOP-) | 5 | | | 6 | JTAG-VREF |
| TCK | 7 | | | 8 | (CHKSTPIN-) |
| TMS | 9 | | | 10 | N/C |
| (SRESET-) | 11 | | | 12 | GND |
| HRESET- | 13 | | | 14 | N/C (KEY PIN) |
| (CKSTOPOUT-) | 15 | | | 16 | GND |
| | |  | | |
- Signals in brackets are not necessary for debugging, but it is recommended to connect those signals if available.
- Pin 8 will be permanently driven to VCCS level by the debugger.
- Signals which are not available should be left unconnected on the debug connector.
- Pin 6 (VCCS) should have a resistance less than 5kOhm for 3.0~5.0V, less than 2kOhm for 1.8~3.0V
Dimension
Connector Type
- This is a standard 16 pin double row (two rows of 8 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 25.5mm/1".
- 100 mil to 50 mil Adapters
- Small Footprint for Target Connector
|
|
Half-Size Adapters for Debuggers
