Adaptation for AVR32

Connector 10 pin

Signal	Pin			Pin	Signal
TCK	1			2	GND
TDO	3			4	VCC
TMS	5			6	RST-
N/C	7			8	N/C
TDI	9			10	GND

Signal recommendations for Mictor 38-pin

• TDI, TDO, TCK, TMS and RST- should be connected directly to the CPU. Don't connect serial resistors or RC combinations to the lines.

• All trace signals should also be routed straight from CPU to the Mictor connector.

• Avoid routing the JTAG signals close to the NEXUS signals.

• VCC is just a sense input and can be connected directly to target VDD, or optional (recommended) with a serial resistor max. 1kOhm

Target Connector for Debugger Adaptation for AVR8/AVR32

Dimension

Connector Type

• This is a standard 10 pin double row (two rows of 5 pins) connector (pin to pin spacing: 2.54mm/0.100").

Half-Size Adapters for Debuggers

100 mil to 50 mil Adapters Small Footprint for Target Connector