BDM Connector for S12


The embedded tools company
Debugger Connector
Target Connector Type and Dimension




Support
Technical Support
 

Debugger Connector


Connector for S12


Signal

Pin

 Pin

Signal

    
BKGD12GND
ECLK34RESET-
N/C56VCC
    

The signal ECLK on pin three must not be connected to the CPU if the ECLK frequency is higher than 25 MHz. The signal VCC on pin six is used to sense if the target has power and to adjust the output drivers to the target's voltage level.  

Target Connector Type and Dimension


Dimension

Connector Type

  • This is a standard 6 pin double row (two rows of 3 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 12.5mm/0.5".




Copyright © 2024 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany   Impressum     Privacy Policy
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 07-Mar-2024