Adaption for Blackfin |
 
|
|||||
|
||||||
| ||||||
Debugger Adaption for BlackFin
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Signal | Pin | Pin | Signal | ||
|---|---|---|---|---|---|
 | |||||
| GND | 1 |  |  | 2 | EMU- |
| N/C | 3 | | | 4 | GND |
| VDDIO | 5 | | | 6 | TMS |
| N/C | 7 | | | 8 | TCK |
| N/C | 9 | | | 10 | TRST- |
| N/C | 11 | | | 12 | TDI |
| GND | 13 | | | 14 | TDO |
 | |||||
| VDDIO | This pin is used by the debugger to sense the target I/O voltage and to set the drive levels accordingly. If the sensed voltage level is too low (e.g. target has no power) the debugger powers down its drivers to prevent the target from damage. |
Dimension
Connector Type
- This is a standard 14 pin double row (two rows of 7 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".
Half-Size Adapters for Debuggers
|
|
Copyright © 2024 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany
Impressum
Privacy Policy
The information presented is intended to give overview information only. Changes and technical enhancements or modifications can be made without notice. Report Errors Last generated/modified: 07-Mar-2024 |
