Adaptation for Arm ETM Preprocessor MIPI-60
Target Adaption of Trace Probe "ETM Preprocessor" for Arm ETM/PTM with MIPI-60
Target Connector Type
Link to SAMTEC
Target Connector Placement
The adaption uses one 60 pin Samtec connector.
We recommend to place the odd numbered pins at the PCB border side (flex cable won't be twisted).
Pinout Depends On Trace Macrocell
ETM = Embedded Trace Macrocell
PTM = Program Trace Macrocell
The pinout of the Samtec MIPI-60 connector optionally includes the debug signals which needs to go to the CombiProbe
(34-pin MIPI header) or to the Debug Cable (20-pin standard header). The Preprocessors have a 34-pin MIPI connector
where the user can plug in the CombiProbe. Alternatively the CombiProbe (or Debug Cable) can be plugged on a
separate connector on the target. In this case there is no need to connect the debug signals to the MIPI-60. For better
signal quality it is better not to connect them. The debug signals are VREF-DEBUG, TCK, TDI, RTCK, TRST-,
DBGACK TRIGOUT, TMS, TDO, RESET-, TRST- PULLDOWN, DBGRQ TRIGIN.
If TRACECTL is not available ("continuous" mode) pin 17 shall be tied to GND.
Copyright © 2023 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 07-Aug-2023