JTAG/COP Connector for PPC603/740/750/8240/8260...

Connectors for PPC603X - PPC750 - MPC5200 - MPC512X - MPC74XX - MPC82XX - MPC83XX - MPC86XX - PA6T

Connector 16 pin

Signal	Pin			Pin	Signal
TDO	1			2	(QACK-)
TDI	3			4	TRST-
(QREQ-)	5			6	JTAG-VREF
TCK	7			8	(PRESENT-)
TMS	9			10	N/C
(SRESET-)	11			12	GND
HRESET-	13			14	N/C (KEY PIN)
(CKSTOP-)	15			16	GND

• Signals in brackets are not necessary for debugging, but it is recommended to connect those signals if available. If not connected, leave the signal N/C on the debug connector.
• Pin 8 (PRESENT, CKSTP_IN) is permanently driven to VCCS level by the debugger.
• Pin 15 is CKSTP or CKSTP_OUT
• Signals which are not available should be left unconnected on the debug connector.
• Pin 6 (JTAG-VREF) must match the JTAG I/O voltage of the processor. JTAG-VREF should have a resistance less than 5kOhm for 3.0~5.0V, less than 2kOhm for 1.8~3.0V.
• Debug cables from March 2004 and older (blue ribbon cable, 3.3V..5V only): Pin 6 (VCC) should be directly connected to VCC.

Dimension

Connector Type

• This is a standard 16 pin double row (two rows of 8 pins) connector (pin to pin spacing: 2.54mm/0.100").
• If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 25.5mm/1".

Half-Size Adapters for Debuggers

100 mil to 50 mil Adapters Small Footprint for Target Connector