Adaptation
The adaptation applies for the following TRACE32® products:
Order No. | Probe |
LA-2717 | Debugger for RISC-V (ICD) out of production |
LA-3200 | Debugger for RISC-V 32-Bit (PACK) |
LA-3201 | Debugger for RISC-V 64-Bit (PACK) |
Converter
Converter IDC20A to RISC-V SiFive PMOD12 fem
Converter IDC20A to RISC-V SiFive PMOD12 male
Converter IDC20A to MIPI-10/20/34
Converter IDC20A to Digilent PMOD™
Converter IDC20A to 10-pin FlashPro01
|
Signal
| Pin
| | Pin
| Signal
|
| |  | | |
VREF-DEBUG | 1 |  |  | 2 | N/C |
TRST- | 3 |  |  | 4 | GND |
TDI | 5 |  |  | 6 | GND |
TMS | 7 |  |  | 8 | GND |
TCK | 9 |  |  | 10 | GND |
RTCK | 11 |  |  | 12 | GND |
TDO | 13 |  |  | 14 | GND |
RESET- | 15 |  |  | 16 | GND |
N/C | 17 |  |  | 18 | GND |
N/C | 19 |  |  | 20 | GND |
| |  | | |
Target connector, top-view |
Note: Pin2, Pin17 and Pin19 must under no circumstances be connected on the target side. Otherwise the hardware of the debugger can get damaged.
Target Connector 20 pin: 2.54mm pin dimension
Target Connector Type
- This is a standard 20 pin double row (two rows of 10 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 30.6mm/1.2".
- Examples with housing: Samtec HTST-110-01-L-D (through-hole); Samtec HTST-110-01-L-DV (surface mount).
- Examples without housing: Samtec TSW-110-23-L-D; Berg 67996-120H.
|